Two-sided sanding brush

DIt is becoming increasingly important to fully utilise materials. The ARMINIUS sanding system has a two-part construction of the individual brush elements. Only the abrasive layer is changed once it wears out,

the backing brush remains in use over the long-term. This means that available materials are fully used.

Another aim is to considerably increase the service life of the abrasive fitting and to tap into potential savings when it comes to setup times. As a result, every side of the sanding element can be supplied with any grain size. This means there is no need to change the sanding brushes for different grain use. The two-sided sanding brush was developed for machines with directional change as well as for machines with 360° rotation, in particular.

You can find single-side cylinder and angle rotor brushes here!

Grit size	Recommended rotational speed (dependant on diameter)
P40-P600	250 – 1500

Each sanding side can be supplied with different grain sizes, all slits are possible, with no limit to the dimensions (tool and sanding elements).

The gap between the individual sanding fittings allows the sanding brush to cool during continuous use.

Contact & Directions

You are currently viewing a placeholder content from Google Maps. To access the actual content, click the button below. Please note that doing so will share data with third-party providers.

More Information

Unblock content Accept required service and unblock content